Ryobi TS1142L Manual del operador descargar pdf (Pagina 28)

ADJUSTMENTS

DANGER:

Laser radiation. Avoid direct eye contact with light

source.

WARNING:

Use of controls or adjustments or performance of pro-

cedures other than those specified herein may result in

hazardous radiation exposure.

TO ADJUST THE LASER GUIDE

See Figures 34 - 36.

 Set miter and bevel angles to 0º.

 Use the work clamp or a C-clamp to secure a piece of

scrap wood.

 Plug the saw into the power source and make a slight cut

to score the wood.

 Release the switch trigger and allow the saw blade to

stop rotating before raising the saw arm.

 Raise the saw arm.

 Unplug the saw.

 Turn on the laser guide.

To adjust the laser angle:

 Loosen the lock screw a 1/4 of a turn so the laser can be

adjusted.

NOTE: Do not remove the lock screw.

 Lower the saw arm, then look into the hole on the back

of the upper blade guard and locate the laser adjustment

screw.

 Using the Phillips end of the blade wrench, rotate the

laser adjustment screw. The laser angle will rotate in the

same direction as the screw.

 Rotate the laser angle clockwise or counter-clockwise

until properly aligned with the cut in the wood.

NOTE: The laser should be parallel with the kerf of the

blade.

 Once aligned, tighten the lock screw.

To adjust the laser left or right:

 Loosen the adjustment screw on the laser bracket.

 Move the laser bracket left or right until the laser is prop-

erly aligned with the cut in the wood.

NOTE: The laser should be on the left edge of the kerf of

the blade.

 Once aligned, tighten the adjustment screw.

NOTE: If laser does not align correctly, return to your

nearest Authorized Service Center for repair.

Fig. 34

Fig. 36

Fig. 35

LOCK

SCREW

ADJUSTMENT

SCREW

BRACKET

HEX KEY

HOLE WITH

SCREW

LASER

1 2 ... 23 24 25 26 27 28 29 30 31 32

Comentarios a estos manuales

Sin comentarios

Ryobi TS1142L Manual del operador Pagina 28

Comentarios a estos manuales

Relacionado con productos y manuales para Sierras circulares Ryobi TS1142L