Ryobi TSS100L Manual del operador descargar pdf (Pagina 31)

OPERATION

wronG

WARNING:

To avoid a kickback and to avoid serious personal injury,

never position the concave edge of bowed or warped

material against the fence.

CLAMPING WIDE WORKPIECES

See Figure 39.

When cutting wide workpieces, such as 2 in. x 6 in., boards

should be clamped with a work clamp as shown in ﬁgure 39.

Fig. 39

wide

Board

Fig. 38

CUTTING WARPED MATERIAL

See Figures 37 - 38.

When cutting warped material, always make sure it is posi-

tioned on the miter table with the convex side against the

fence as shown in ﬁgure 37.

If the warped material is positioned the wrong way as shown

in ﬁgure 38, it will pinch the blade near the completion of

the cut.

Fig. 37

riGht

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Sin comentarios

Ryobi TSS100L Manual del operador Pagina 31