Ryobi EJ101 Manual del operador Pagina 14

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 20
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 13
Page 14
WARNING:
When servicing use only identical Ryobi replacement parts. Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear safety goggles or safety glasses with
side shields during power tool operation or when
blowing dust. If operation is dusty, also wear a dust
mask.
WARNING:
To prevent serious personal injury, never do
maintenance or repairs with unit running. Always do
maintenance and repairs on a cool unit. Disconnect
spark plug wire to make sure the unit will not start.
NOTE: Some maintenance procedures may require special
tools or skills. If you are unsure about these
procedures take your unit to an authorized service
center.
MAINTENANCE SCHEDULE
These required maintenance procedures should be
performed at the frequency stated in the table. They should
also be included as part of any seasonal tune-up.
MAINTENANCE
FREQUENCY MAINTENANCE REQUIRED REFER TO:
Before Starting Engine Fill fuel tank with correct oil and fuel mixture. Page 11
Every 10 Hours Clean and re-oil air filter. Page 16
Every 50 Hours Clean carbon build up from muffler Page 16
Every 50 Hours Check spark plug condition and gap. Page 17
Vista de pagina 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios