Ryobi OSS500 Manual de usuario Pagina 1

Your new oscillating spindle sander has been engineered and manufactured to Ryobi's high standard for dependability,ease of operation, and operat

10ADJUSTMENTSREMOVING SANDING SLEEVESSee Figure 3.Follow these directions to remove sanding sleeves. Unplug the sander.WARNING:Failure to unplug the

11ADJUSTMENTSFig. 5THROATPLATEHEX NUTUPPERSPINDLEWASHERSANDINGSLEEVESPINDLEWRENCHLOWERSPINDLEWASHERINSTALLING 1/2 INCH (12.7 mm) SANDINGSLEEVESSee Fig

12OPERATIONWARNING:Always wear safety goggles or safety glasses withside shields when operating this tool. Failure to doso could result in dust, shavi

13OPERATIONOPERATING THE SANDERSee Figures 8 and 9.Follow these directions to operate the sander. Insert the switch key. Turn on the sander by lifti

14WARNING: When servicing use only identical Ryobi replacement parts. Use of any other parts may create a hazard or causeproduct damage.GENERALAvoid

15NOTES

OPERATOR'S MANUALOscillating Spindle SanderOSS500 - Double InsulatedRYOBI TECHNOLOGIES INC.1428 Pearman Dairy Road Anderson, SC 29625Post Office

2INTRODUCTION Introduction ...

3RULES FOR SAFE OPERATIONSafe operation of this power tool requires that you readand understand this operator's manual and all labelsaffixed to t

4RULES FOR SAFE OPERATION DO NOT USE TOOL IF SWITCH DOES NOT TURNIT ON AND OFF. Have defective switches replacedby a qualified service technician at

5RULES FOR SAFE OPERATIONThe purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and theexplanations with

6SPECIFICATIONSOscillating Range 5/8 in. (15.9 mm)Oscillations Per Minute 58 OPMSpindle Size 1/2 in. (12.7 mm)No Load Speed 2000 RPMInput 120 Volts, 6

7Before using the oscillating spindle sander, familiarizeyourself with all operating features and safetyrequirements. However, do not let familiarity

8FEATURESFig. 1WARNING:Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any suchalteration or modifica

9ADJUSTMENTSWARNING:The sander should never be connected to a powersupply when you are assembling parts, making ad-justments, cleaning, or when not in