Ryobi DBJ50 Instrucciones de operaciones descargar pdf (Pagina 135)

Page 126 Power Equipment Usage Manual (Rev. 5/10)

31. STAPLER – PNEUMATIC (Grizzly Model G6042, Porter-Cable NS150A )

(NOTE: Portions of the information presented in this section were taken from the Grizzly Operating

Manual.)

The stapler is designed to install 1/4 crown staples of various lengths from 5/16” to 1” (8 to 25 mm)

long. This stapler is used to fasten thin workpieces.

31.1. Safety Precautions

a. CAUTION: Keep tool pointed away from yourself and others at all

times.

b. Disconnect the tool from air supply before clearing jams, performing

repairs, and during non-operations.

c. Do not keep the trigger pulled on safety yoke mechanism when

carrying or holding the tool.

d. Never carry the tool by the hose or pull the hose to move the tool.

e. Operating this stapler can propel objects into the air, causing immediate eye damage. To protect

yourself, you should wear safety glasses or goggles when operating this equipment.

f. This stapler discharges at 85-90 decibels. To protect your hearing, you should wear ear

protection when operating this stapler.

31.2. Setup & Use – Pneumatic Air/Oil

Pneumatic tools need to receive a continuous supply of oil as

well as air. In the Woodshop, that supply comes by routing the

compressed air coming from the compressor through the black

automatic oiler shown in this picture.

The blue device in this picture regulates the air pressure and it

needs to be checked to make sure the pressure is set between

85-90 PSI before connecting the tool. There are several such

setups in the Woodshop.

The picture shows the pressurized air and automatic oiler system located by the sanding table.

31.3. Setup & Use – Stapler

31.3.1. Safety Yoke Mechanism

A safety yoke mechanism (bump fire) on the nose of the stapler acts as a secondary safety device. When

the trigger is pressed, the stapler will not fire until the safety yoke mechanism is depressed.

1 2 ... 130 131 132 133 134 135 136 137 138 139

Sin comentarios

Ryobi DBJ50 Instrucciones de operaciones Pagina 135