Ryobi AG453K Manual de usuario descargar pdf

In addition to the items listed in the Packing List of the Angle

Grinder Operator’s Manual, this kit also includes:

n Wire Wheel Brush: Suitable for removing paint or rust

from metal surfaces

n Abrasive Mop Disc: Suitable for sanding flat metal or

wood surfaces

n Case

WARNING:

To reduce the risk of injury, user must read and understand

the operator’s manual for the angle grinder before using

these accessories.

INSTALLING/REPLACING WIRE WHEEL OR

ABRASIVE MOP DISC

See Figures 1 - 2.

n Unplug the angle grinder.

n Depress and hold the spindle lock button and rotate nut

with provided wrench until spindle locks.

NOTE: To prevent damage to the spindle or spindle lock,

always allow motor to come to a complete stop before

engaging spindle lock.

n Loosen and remove flange nut from spindle. Do not

remove disc flange.

n Make sure flats on the bottom of disc flange are engaged

with flats on spindle.

n Place the wire wheel or abrasive mop disc over the

spindle.

WARNING:

Always install abrasive mop disc with the depressed

center against the disc flange as shown. Failure to do so

will cause the disc to crack when tightening the nut. This

could result in serious personal injury because of loose

particles breaking off and being thrown from the angle

grinder. Do not overtighten.

n If installing wire wheel brush, thread the nut on the spindle

with the flat side of flange nut facing UP. Fit raised, small

diameter portion of the nut into the hole in the wheel and

finger tighten.

If installing abrasive mop disc, thread the flange nut on

the spindle with the flat side of nut facing DOWN. Finger

tighten.

n Depress and hold the spindle lock button and rotate the

wheel clockwise until the spindle locks in position.

n Securely tighten the flange nut with the wrench provided.

Do not overtighten.

Spindle lock

Flat(S)

Wrench

tighten

Flange nut

turned

correctlY

looSen

Wire

Wheel BruSh

nut turned

incorrectlY

diSc

Flange

aBraSiVe

Mop diSc

Spindle

Spindle lock

Flat(S)

Wrench

tighten

Flange nut

turned

correctlY

looSen

nut turned

incorrectlY

diSc

Flange

Spindle

Fig. 1

Fig. 2

OPERATOR’S MANUAL ADDENDUM

AG453K

1 2 3 4

Indice de contenidos

Pagina 1 - OPERATOR’S MANUAL ADDENDUM

In addition to the items listed in the Packing List of the Angle Grinder Operator’s Manual, this kit also includes:n Wire Wheel Brush: Suitable for r

Pagina 2 - AVERTISSEMENT :

En plus des articles énumérés sur la liste des pièces du manuel d’utilisation de la meuleuse angulaire, cette ensemble inclut également :n Brosse mét

Pagina 3 - ADVERTENCIA:

APÉNDICE DEL MANUAL DEL OPERADORAG453KAdemás de los elementos enumerados en la Lista de empaquetado del Manual del operador de la esmeriladora angular

Pagina 4 - ONE WORLD TECHNOLOGIES, INC

9900005191-14-13 (REV:01)ONE WORLD TECHNOLOGIES, INC.1428 Pearman Dairy Road, Anderson, SC 29625 • Phone 1-800-525-2579 États-Unis, Téléphone 1-800-52