Ryobi JS550LK Manual de usuario descargar pdf (Pagina 15)

-12-

Steel Ball D3.97 [62]

Spring (C) [61]

Change Knob [60]

Retaining Ring (E-Type) Fo

D5 Shaft [44]

● Reassembly of Change Knob

Reverse the disassembly procedures above to reassemble the jig saw. However, pay particular attention

when reassembling the jig saw.

1. Reassembly of Change Knob

(1) Reassemble Spring (C) [61] and Steel Ball D3.97 [62] in Change Knob [60] as shown in the following

diagram:

2. Checking Insulator length

Do not strip too much insulation from the end of each lead wire for connection.

Be careful not to let the lead wire be clamped by the joint of Housing (A).(B) Set [36].

3. Other precautions

(1) Make sure Earth Terminal [54] is completely inside Housing (A).(B) Set [36] before closing the set.

Otherwise, the set will be deformed.

(2) Be sure to reassemble Spring [13] and Plate Nut [64], which are often overlooked and not mounted.

Reassembl

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Sin comentarios

Ryobi JS550LK Manual de usuario Pagina 15