Ryobi DBJ50 Instrucciones de operaciones descargar pdf (Pagina 56)

Page 47 Power Equipment Usage Manual (Rev. 5/10)

• Loosen Bevel Latch Lock Handle.

• Unlock a Bevel Latch Lever (one on each side).

• Move saw left or right to desired angle of cut.

• Lock Bevel Latch Lever.

Basics of making a cut:

• Line up the cut mark with the blade.

• Depress trigger switch to turn ON:

o Allow blade to reach full RPM before making cut.

o Hold stock firmly against table and fence.

o Do not force blade down – Lower saw head smoothly and slowly.

• Release the trigger switch to turn OFF.

o Allow the blade to stop before raising saw head.

Crosscuts (Cutting stock across grain at any angle):

• Stock smaller than 2x8” – Tighten Rail Lock Knob to prevent saw from sliding forward on

rails.

• Stock larger than 2x8” (or 2x6” if at 45 degree miter):

o Loosen Rail Lock Knob.

o Pull saw out toward you.

o Lower saw head down toward workpiece.

o Slowly push saw back to complete cut.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 138 139

Sin comentarios

Ryobi DBJ50 Instrucciones de operaciones Pagina 56