Ryobi DBJ50 Instrucciones de operaciones descargar pdf (Pagina 97)

Page 88 Power Equipment Usage Manual (Rev. 5/10)

17.2. Set Up & Use – Hollow Chisel Mortiser

17.2.1. Installing a Chisel & Bit

a. Loosen lock screw, shown in Figure 1.

b. Insert chisel bushing (with the hole facing forward) into

the head. Tighten the screw just enough to hold the chisel

in place.

NOTE: Set the slot in the side of the chisel to the left or

right, NOT to the front or back. This will allow chips to

escape when cutting mortises.

c. Push the chisel up as far as possible into the head. Then

lower the chisel approximately 1/16" to 3/16", depending

on the type of wood being worked. Tighten the screw to

hold chisel in place.

Figure 1

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 138 139

Sin comentarios

Ryobi DBJ50 Instrucciones de operaciones Pagina 97