Ryobi RTS30 Manual del operador descargar pdf (Pagina 18)

ASSEMBLY

TO INSTALL THE HANDLE

See Figure 9.

 Hold the nylon nut securely and turn the screw counter-

clockwise to remove the nut completely.

NOTE: Do not remove the screw from the handle.

 Place the nylon nut into the recessed hole on the back

of the height/bevel adjusting handwheel and hold in

place.

 Slide the handle, screw, and washer into the hole on the

height/bevel adjusting handwheel.

 Using a flathead screwdriver, turn the screw clockwise

and tighten in place.

TO INSTALL THE LOCKING LEVER

See Figure 10.

 Slide the locking lever over the exposed end of the rip

fence making certain the handle is inserted as far as

possible.

 Align the holes in the rip fence and the holes in the lever.

Secure using the screws.

TO REMOVE/REPLACE THE THROAT PLATE

See Figure 11.

 Lower the blade by turning the height/bevel adjusting

handwheel counterclockwise.

 To remove the throat plate, place your index finger in

the hole and lift the front end pulling the throat plate out

toward the front of the saw.

 To reinstall the throat plate, slip the tab into the slot at

the back of the saw and push down to secure in place.

RIP

FENCE

LOCKING

LEVER

SCREWS

HEIGHT/BEVEL

ADJUSTING HANDWHEEL

Fig. 10

Fig. 9

SCREW

NYLON

NUT

WASHER

HANDLE

Fig. 11

THROAT

PLATE

SPREADER/ RIVING

KNIFE

Fig. 11

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 41 42

Comentarios a estos manuales

Sin comentarios

Ryobi RTS30 Manual del operador Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas Eléctricas Ryobi RTS30