Ryobi RTS30 Manual del operador descargar pdf (Pagina 20)

ASSEMBLY

TO CHECK SAW BLADE INSTALLATION

See Figure 13.

CAUTION:

To work properly, the saw blade teeth must point down

toward the front of the saw. Failure to do so could cause

damage to the saw blade, the saw, or the workpiece.

 Unplug the saw.

 Lower the saw blade and remove the throat plate.

 Make sure the bevel locking lever is securely pushed to

the right. Raise the saw blade to its full height by turning

the height/bevel adjusting handwheel clockwise.

 Place spreader/riving knife in “up” position.

To loosen the blade:

 Using the open end blade wrench, place the at open

end on the ats on the arbor shaft.

 Insert the closed end blade wrench over the blade nut.

Holding both wrenches rmly, pull the closed end wrench

forward to the front of the machine.

To tighten the blade:

 Using the open end blade wrench, place the at open

end into the ats on the arbor shaft.

 Insert the closed end blade wrench over the blade nut.

Holding both wrenches rmly, push the closed end wrench

to the back of the machine. Make sure the blade nut is

securely tightened. Do not overtighten.

 Reinstall the throat plate.

 Check all clearances for free blade rotation.

OPEN END BLADE

WRENCH

CLOSED END BLADE

WRENCH

BLADE NUT

Fig. 13

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 41 42

Sin comentarios

Ryobi RTS30 Manual del operador Pagina 20